Intelligent PIR detector for home burglar alarm working with
security ip camera system
This product is a high stability wireless passive infrared
detector(PIR sensor). It uses advanced Signal processing
technology, provides high performance for detection and anti-false
alarm. When an intruder is going through the detection area, the
detector will automatically detect the activities of the human body
in the region. If there is a dynamic phenomenon, it sends the alarm
signal to the control host. This product is suitable for family
residential district, residential villas, factories, shopping
malls, warehouses, office buildings and other places for safe
Power Requirements: DC9V(battery not including)
Power Requirements: 7mA~8mA (While sending)
Power Requirements: 45uA(While monitor)
Operating Freqency: 433Mhz
Angle detection between upper and lower: 60°
Angle detection between left and right: 110°
Bracket Adjustable Angle: -45° to +45°(Horizontal line)
Bracket Adjustable Angle: -15° to +45°(Vertical line)
Response Time: 6s
Coding Type: Fixed Code
Installation: wall mounting or wall corner mounting
Working temperature: -10℃-+50℃
Ambient humidity: 5%~95%RH
Product size: 107*56*39.5mm
Shell Colour: White
When installing, you choose the favorable positions according to
the environment. The lens is faced to the required surveillance
locations. The installing height should be 2~2.5 meters above the
ground. Pull out the antenna of the movement detector. Push down
the power switch of the movement detector to position "on". After
60 seconds delay, the movement detector will enter the automatic
detection state. Anybody movement within detection, the movement
detector will send alarm message to the main unit.
- It should be avoided to be installed in the outdoor, for example,
the places where pets/rotating objects come and go, the places
around air conditioning or the heat source machine, the place where
the sunshine direct to.
- the mounting surface should be strong, and no vibration.
- The detector is installed in the place where the intruder is easy
- the detector bracket is firmed with screws on the wall.
- the detector will be hung up on the bracket.
2, product testing
Connected to the power, the LED light indicates a second, then the
detector will be into the self-test state, self check time is about
30 seconds. After 30 seconds, the detecor will be into the normal
state of monitoring. The tester should walk within the detection
range, and the LED indicator light is on, it means that the
detector is in the alarm state.